BC-5565 Ordinary Self-Sealing Bag Film Blowing Machine

Cleaning and Maintenance of Self sealing Bag Blowing Film Machine

1. When cleaning the extruder and die, copper knives, rods, or compressed air can be used for cleaning, but do not damage the screw and the smooth surface of the screw.

2. Before starting up the machinery, it is necessary to inspect the deceleration device and lubrication device to avoid damage to the machine and noise caused by dry operation.

3. Within the range of film-forming conditions, increase the molding temperature, cooling air temperature, and blowing expansion ratio; So the turbidity of the film increases and the glossiness decreases; On the contrary, it increases.

When the discharge from the mold mouth is uniform and consistent, you can wear gloves and slowly pull the tube blank. At the same time, close the end of the tube blank, slightly open the air inlet control valve, and put a small amount of compressed air into the center hole of the core rod. Then, carefully guide it through the stable foam holder and the herringbone plate, and thread it into the traction roller and guide roller until it is rolled (if you want to emboss, you need to pass through the embossing roller)

5. The compressed air pressure for blowing and expanding the tube blank should be appropriate, which should not cause the tube blank to rupture, but also ensure the symmetry and stability of the membrane tube, relatively ensuring the quality of production